Page 80
22.10.2019
R01.43
This function is available from user level "admin". Adds a new aflex module
Delete the aflex module (2)
This function is available from user level "admin". Deletes the currently selected aflex
module
Save the aflex module (3)
This function is available from user level "advanced". Saves the setting of the aflex
module.
Select the used client nodes (4)
This function is available from user level "Admin". The necessary client nodes are as-
signed to the aflex software module. If no client is assigned, "0" is displayed. A serial
number is displayed for an already assigned driver. By clicking on the display ("0" or
respective serial number), the option for assigning the clients opens.
Help page(5)
Opens an extract from the manual.
Transfer the selection to the control unit (6)
This function is available from user level "admin". Transfers the selected client nodes
to the control unit. Caution: These are stored in the permanent memory only after sav-
ing ("Save to EEPROM" / "save all").
Display of the assigned channels (7)
The individual driver channels are assigned to the aflex actuators, which is also re-
ferred to as mapping.
INSTRUCTION
The mapping and electrical wiring must match. The mapping is
preconfigured in the delivery state and the electrical wiring
should therefore be carried out according to the instructions. The
drivers for vertical and horizontal actuators must not be inter-
changed.
Assign channel/Delete connection (8)
