Maintenance and repair
100 – 112
Assembly instructions EN
EPS Handling systems
Date 08.09.2021
Version 2.0
8 Maintenance and repair
8.1 General notes
The EPS system is almost maintenance-free. Nevertheless, some maintenance
work must be carried out to ensure an optimum operating condition of the EPS.
EPS systems are high-performance devices with very short cycle times. The
service life of the units depends mainly on the ambient conditions and
maintenance.
It is therefore essential to follow the maintenance instructions for the
individual modules!
8.2 Safety instructions for Maintenance and Repair
Also observe the safety instructions in
chap. 2 „Safety instructions“ in this
manual.
DANGER
Risk of injury due to electric shock!
If work on electrical components is required, ensure that the work is carried
out properly, failure to do so will cause serious or fatal injuries.
All work on the module must be carried out with the power supply cut off!
Switch off the power supply and secure it against being switched on again.
DANGER
Risks by the pneumatic system!
If work on electrical components is required, ensure that the work is carried
out properly, failure to do so will cause serious or fatal injuries.
All work on the systems must be carried out with the power supply cut off!
Switch off the compressed air supply and secure it against being switched
on again.
WARNING
Danger of injury due to improper maintenance!
Improperly carried out maintenance activities can cause considerable
damage to property and serious injury.
Only use trained specialist personnel to carry out the activities.
Always wear personal protective equipment when carrying out maintenance
and repair work!
