Decommissioning and disposal
106 – 112
Assembly instructions EN
EPS Handling systems
Date 08.09.2021
Version 2.0
9 Decommissioning and disposal
The EPS must be properly dismounted after use and disposed of in an
environmentally friendly manner.
9.1 Safety instructions for decommissioning and disposal
9.2 Decommissioning
If the EPS is not used for a longer period, it must be properly decommissioned
and stored as described in
chapter 4.4.
9.3 Disposal
The EPS system must be disposed of properly at the end of their service life
and the raw materials used must be recycled. Observe the legal regulations and
company requirements.
The EPS system must not be disposed of as a complete unit. Dismantle the
EPS system and separate the various components according to type of material
and dispose of them properly: Information on proper disposal can be obtained
from the responsible local authorities.
WARNING
Risk of injury due to improper decommissioning and disposal!
Improperly carried out activities can result in considerable material damage
and serious injury.
Only use trained specialist personnel to carry out the activities.
Disconnect the media supply before dismounting the module!
Only remove the EPS system when the control unit is switched off and
secured!
NOTICE
Risk to the environment due to incorrect disposal of the packaging
material of the EPS!
Environmental damage can be caused by improper disposal of the EPS.
Products that are predominantly made of metal (axles, modules, adapter
plates, etc.) must be disposed of according to national law for metal
recycling
Electronic products (regulators, controllers, etc.) must be disposed of in
accordance with national legislation on electronic waste.
Electronic parts, electrical scrap, auxiliary and operating materials must
be disposed of by approved specialist companies.
