1
7
5
S
ERIES
A
FC
O
-R
AIL
L
EVEL
C
ABLE
R
AIL
x
Read the instructions completely before beginning the installation.
x
Plan your railing project. Sketch your project with the actual measurements of your deck or balcony
x
complete with post locations.
x
Check local building codes to ensure compliance.
x
Check carton(s) to determine part count is complete.
x
After cutting rails, balusters, or posts, paint exposed metal for maximum protection against the elements.
x
Installation is best accomplished with two people.
x
Wear personal protection equipment; safety glasses, etc.
x
Use care not to over-torque the screws. Pre-drilling is recommended.
x
Provided hardware to install AFCO-Rail is for use with Aluminum AFCO-Rail posts. If installing to other
surfaces the installer must acquire the appropriate hardware as needed for proper installation.
FOR A SUCCESSFUL INSTALLATION:
TOOLS REQUIRED:
x
Drill bit
5/32
" (.156")
x
Drill Bit 9/32” (.281)
x
Drill bit 29/64” (.453)
x
1/8” hex wrench
x
7/16” wrench
x
Drill (with adjustable clutch, recommended)
x
Miter Saw (with metal cutting blade)
x
Level
x
Rubber mallet
x
Tape measure
x
Cable cutters
x
Grinder with cutoff wheel
x
Touch-up paint
NOTES:
x
NOTE: Cables for this rail system are sold
separately.
x
Posts packaged separately.
x
An Optional AFCO-Tool is available to simplify the
locating, pre-drilling and installation of
brackets.
PARTS INCLUDED:
TOP RAIL—TOP RAIL (1)
BOTTOM RAIL— BOTTOM RAIL (1)
A
B D
SADDLE
BRACKET
(2)
BRACKET
COVER
(2)
BOTTOM
BRACKET
(2)
10”
SUPPORT
BLOCK
(1)
C
D
E
F
SUPPORT
BLOCK
CONNECTOR
(2)
#10
X
1”
SELF
DRILLING
SCREW
(12)
3 1/2 “
DRIVER
BIT
(1)
ADHESIVE
TAB
SHEET
(1)
G
H
I
J
H
INSTALLATION INSTRUCTIONS
Series 175 AFCO
Series 175 AFCO
Series 175 AFCO
–
–
–
Level Cable Rail
Level Cable Rail
Level Cable Rail
PRE
-
DRILLED
CABLE
BALUSTER
K
