9
INSTALLATION INSTRUCTIONS
IDEAA
®
Mini Interior Distribution Cabinet
© 2016, AFL, all rights reserved. Revision 0, 4.27.17
Specifications are subject to change without notice.
Figure 13
4. Re-mount the cover plate with the attached IDEAA module into the desired location, using the screws removed
in Step 2.
(Figure 12)
5. Repeat Steps 1 – 4 for each IDEAA Splitter Module that needs to be mounted.
Figure 12
An IDEAA Splitter Module that has been mounted into the IDC is not active until it has been connected to the Input Field.
Caution: When working with fiber optics, do not look directly into the end of the fiber cable or adapter
port. A power meter may be used to determine if the cable or port is dark. Or use locally accepted fiber
optic safety practices.
1. Use local accepted practices to clean the connector end face at both ends of the jumper provided with the Mini IDC.
2. Plug the jumper cable into the black input port on the IDEAA Splitter Module.
Note: When mounted on the cover plate the black input port will be located in the top right corner of the
adapter field. (Figure 13)
ACTIVATE IDEAA SPLITTER MODULE
Figure 13
