10
Low Heating
At default interface, press button D(MENU) twice to display L and flashing
heating icon as following:
Press OK button to set temperature. The default temperature is 10°C(50°F).
It’s displayed as following:
Press button E(+) or F(-) to adjust temperature. If the set temperature is higher
than the room temperature detected by appliance, the heating starts. The
heating will not start if the set temperature is lower than the room temperature.
Celcius/Fahrenheit Setting:
The default temperature readout is Celcius. Long press button D(MENU) for 3
seconds then press button E(+) or F(-) to change the temperature readout
from Celcius to Fahrenheit.
Brightness Control
Brightness Control is to select the desired flame brightness level.
At default interface, keep pressing button D(MENU) to select the Brightness
Control, it’s displayed “bri” and flashing light bulb icon as following:
Press OK button to start the brightness setting. Press button E(+) or F(-) to
select the brightness level.
5 brightness levels are selectable. Default setting is 3. 5 is the highest level as
shown following:
www.aflamo.pl/en/
