© Copyright LOTRONIC 2016
Page 3
damage the machine.
•
To fill the tank, put the machine on a level place, open the liquid tank and pour high quality haze liquid into the
tank. Close the tank immediately after filling it.
•
It’s forbidden to spray directly towards persons. Keep far away from flammability and explosive objects
•
The haze is very hot, please keep a distance of at least 5 meters when using it
•
Please don’t touch the surface of the haze machine during the use because the housing will reach 40-80°C
•
When the machine doesn’t work, please check if the fuse is burnt out or not. If it is, replace it by an identical fuse,
find out the fault and restart the machine. But please note: the repair must be handled by professional.
Wireless remote Control
There is one transmitter and one receiver included. You may control up to 4 independent fog machines, or as many
as you want simultaneously. See the below instructions to how to operate the wireless remote.
1. Plug the wireless receiver into the fog machine’s 5-pin connector on the rear panel saying “Wireless Controller”.
2. There are 4 buttons on the transmitter. Each button can be assigned to a different fog machine. You may only
choose 1 DIP switch on each receiver. See the below configuration for setting the receivers to operate with the
transmitter.
CH1 1=On,2-4=Off
CH2 2=On,1,3,4=Off
CH3 3=On,1,2,4=Off
CH4 4=On,1,2,3=Off
During heating time, the heating led lights on. When the fog is ready to spray, the status led lights on.
DMX Function
There are 2 DMX channels as follows:
Channel1: Fan output 0-10 OFF; 11-255 increase
Channel 2: HAZE output: 0-10 OFF, 11-255 increase
When the unit is connected to DMX, the LCD display will show the address value. Press UP/DOWN buttons to
change the address.
Fluid Sensor Protection Function
The unit has a control program that checks whether fluid is present to protect the pump.
1.1 Activation of the Fluid sensor
Wireless receiver
Wireless remote
control
Switch
Heating Led
Status led
