Ag Leader Technology 4200140, Installation Manual

Ag Leader Technology

DirectCommand Installation

Raven Accu-Flow ISO Kit

Page 12 of 15 

February 2015 

PN: 2006375 Rev. B 

Installing an 
Implement 
Switch 
(Optional)

Parts required for procedure: 



  (1) Implement Switch  

PN: 4001507 



  (1) Implement Switch Ext. Cable 

See Table B 



  (1) CAN Implement Switch Cable 

PN: 4002658 



  (1) CAN Implement Switch Module 

PN: 4002911 

Table B 

Implement Switch Extensions 

Part Number 

18 in. Cable 

2000453-1 

42 in. Cable 

2000453-4 

10 ft. Cable 

2000453-2 

25 ft. Cable 

2000453-3 

NOTE: If using this kit on an implement that is raised out of the ground 
when not applying, it is recommended to install an optional Implement 
Switch. This will prevent the controller from turning on product flow 
when the implement is out of the ground and over an unapplied area 
of the field. 

Step-by-Step 

instructions for 

installing an 

Implement 

Switch 

(Optional) 

1.  Decide on a location for mounting the Implement Switch. 
  
2.  The mounting orientation of the implement Switch Assembly 

determines whether the lever is off center or centered when the 
implement is in the “application” position.  

3.  For an off center orientation plug the 3-pin Weatherpack Shroud 

labeled 

NORMALLY OPEN 

on the Implement Switch into the 3-pin