AGA marvel Mercury MMCFDR23, User Instructions

15

ELECTRONIC CONTROL

Sabbath mode

The Sabbath Mode is a feature that disables portions

of the refrigerator and its controls for, in accordance with 

observance of the weekly Sabbath and religious holidays 

within the Orthodox Jewish community.

Sabbath Mode is turned ON and OFF by pressing and 

holding the freezer temp “-” and the refrigerator temp “+” 

indicators for five seconds. The display shows “Sb” while in 

Sabbath mode.

In the Sabbath Mode, the High Temp alarm is active for 

health reasons. If a high temperature alarm is activated 

during this time, for example due to a door left ajar, the 

alarm will sound intermittently for about two minutes. The 

alarm will then silence on its own and a red high tempera-

ture icon will display. The high temp icon will continue to 

display, even if the door is closed, until the Sabbath mode 

is exited and the icon reset. The refrigerator will function 

normally once the door is closed, without any violation of 

the Sabbath/Holidays.

NOTE

NOTE

NOTE

While in Sabbath Mode, neither the lights nor the control 

panel will work until Sabbath Mode is deactivated. Refrig-

erator stays in Sabbath Mode after power failure recovery. 

It must be deactivated with the buttons on the control panel.

During Sabbath Mode, the ice maker is turned off by main 

control board.

Sabbath Mode and the Select Temp 

Drawer

The Select Temp Drawer should be turned off for the 

Sabbath/Holidays. Before putting the refrigerator into the 

Sabbath mode, turn the Select Temp Drawer off by press-

ing the drawer on/off button. The display will show “OFF” 

and the drawer will turn off. Then enter the Sabbath mode 

function on the main refrigerator display. See the electronic 

control “Sabbath Mode” section. When in Sabbath mode, 

the display will not illuminate and the drawer will remain 

off. The drawer can still be used as a non-temp controlled 

drawer in this mode. When the refrigerator is taken out of 

Sabbath mode, the Select Temp Drawer will have to be 

turned back on.

If the Select Temp Drawer is not turned off prior to putting 

the unit into Sabbath Mode, it will continue to adjust itself to 

maintain the set point even if the display does not illuminate 

to show that it is still on.