21
!
CAUTION
The water supply to the ice-maker must be turned on prior
to turning the ice-maker on. Failure to do so will cause
rapid dry cycling of the ice-maker mold heater resulting in
temperature control issues in the freezer compartment.
CARE AND CLEANING
Figure 23
Clean out
debris
Remove screws
around perimeter
of access cover.
Soak up
water from
plastic drain
pan if
necessary
Access cover
Solenoid
cover and
3 screws
To disconnect the water outlet line:
Push up on the white
collar and pull the plastic water line from the bottom of the
water valve.
To reconnect the water outlet line:
Simply insert the plas-
tic tubing into the white collar and push until it stops (about
1
⁄
2
", 12 mm, of water line will enter the valve).
White
collar
Plastic outlet
water line
Figure 23a
Start-Up After Long-Term Storage:
1.
If stored outside, it is recommended that the unit again
be thoroughly inspected per the storage instructions
above to address any dirt or debris from the weather
and/or animals/insects.
2. Connect the unit to electrical power and the water sup-
ply.
3.
Turn unit on and confirm your desired control settings.
4. Allow 24-hrs for the unit to stabilize before loading
contents.
