12
Freezer
Automatic Ice Maker
Operation
Wire Shelf Adjustment
You can easily adjust your freezer’s shelves. To remove a shelf, simply tilt it up at the front,
releasing the hooks from the shelf support. Then, pull the shelf straight out. To replace,
guide the rear hooks of the shelf into the slots in the shelf supports. Then, tilt the shelf up
at the front until the hooks drop into the slots. Next, lower the front of the shelf to a level
position.
The ice maker and slide-out ice drawer on your refrigerator are not adjustable, but the ice drawer slides forward for
easy access to ice.
After the refrigerator reaches normal temperature, the ice maker fi lls with water and begins operating. Under normal
conditions, the ice maker will produce seven to nine batches of ice per 24 hour period.
Note:
Allow 24 to 48 hours after installation before looking for ice in your ice drawer.
You should discard the fi rst three full drawers of ice produced by your refrigerator,
and should also throw out the fi rst drawer full of ice your refrigerator produces after
extended periods of non-use.
During ice production, the ice maker arm raises and lowers. When the ice bin is
full, the ice maker arm automatically turns the ice maker off. To manually stop ice
production, raise the ice maker arm. You will hear a defi nite click when you have the
arm in the right position. The ice maker won’t produce any more ice until you lower
the ice maker arm.
CAUTION
To avoid damage to ice maker, observe the following:
•
DO NOT
force ice maker arm down or up past stop position.
•
DO NOT
place or store anything in ice bucket.
On
Position
Ice
Maker
Arm
Off
Position
Wire Basket Adjustment
You can easily adjust your freezer’s wire baskets by moving the dividers. To remove a
divider, simply grasp it in the center, and pull the divider straight up. To replace, guide
the divider around the basket wires in the desired location, then push the divider down
until it stops.
Ice Bin Adjustment
Ice bins can be adjusted to match the way you use your freezer. The ice bin on
the left-hand side is used for collecting ice from the ice maker. Once the left-
hand ice bin is full, the bins can be reversed so additional ice is made. If the ice
maker is not operating, the ice bin can be used for cold storage.
Ice Bin below
icemaker
