13
Electrical Connection
n
Any electrical work that is required to install this
appliance MUST be carried out by a qualified
electrician.
n
WARNING: This appliance must be earthed.
Before making any electrical connections, ensure that:
• Electrical safety is only guaranteed when the earth
system of your house in accordance with the related
local regulations.
• Do not bend, stretch or pull the supply cable to avoid
electric shock.
• Ensure the power socket is suitable for the Maximum
power of the machine {fuses in the power circuit must
be 13 amp).
• The supply voltage should be the same as that indicated
in the technical specifications and the appliance rating
plate.
• The appliance should be earthed and in compliance
with the applicable law.
• When installed, the power socket must be within easy
reach.
• If the socket outlets in your home are not suitable for
the plug supplied with this unit check with a qualified
electrician for replacement.
• To avoid the risk of overloading your plug socket, the
use of adapters, multiple connectors or extension
cables are not recommended. The appliance must be
connected to a
220-240 volt S0Hz AC
supply by mean
of a three pin socket, suitably earthed and protected by
a 13 amp fuse. Should the fuse need to be replaced, a
13 amp fuse approved to
BS1362/ A
must be used.
• The plug contains a removable fuse cover that must
be refitted when the fuse is replaced. If the fuse cover
is lost or damaged, the plug must not be used until
a replacement cover has been fitted or the plug is
replaced.
• A damaged plug should be cut off as close to the plug
body as possible, the fuse should be removed and the
plug disposed of safely.
• When positioning the appliance, ensure the supply cord
is not trapped or damaged.
• Do not locate multiple portable socket-outlets or
portable power supplies at the rear of the appliance.
Plug replacement (UK & lreland only)
Should you need to replace the plug; the wires in the power
cable are coloured in the following way:
Blue - Neutral ‘ N’
Brown - Live ‘ L’
Green & Yellow - Earth ‘E’
The green & yellow wire must be connected to the terminal
in the plug that is marked with the letter E or by the earth
symbol.
The blue wire must be connected to the terminal that is
marked with the letter N.
The blue wire must be connected to the terminal that is
marked with the letter L.
If power supply cord is damaged, it must replaced by the
manufacturer or its service agent or a similar qualified person
in order to avoid a hazard.
Connect green/yellow lead
to the ‘
E
’ or Earth
Connect brown lead
to the ‘
L
’ or Live
Connect blue lead
to the ‘
N
’ or Neutral
