CARE AND CLEANING
The light tubes are not covered by your warranty. Replacement
tubes can be obtained from your dealer or from AGA.
In the Event of a Power Failure
If a power failure occurs, try to correct it as soon as possible.
Minimize the number of door openings while the power is off so
as not to adversely affect the unit’s temperature.
Disposal
When you dispose of this product, do so in a way sympathetic
to the environment. For further information, contact your local
authority.
Do NOT under any circumstance use a light tube that exceeds 10
watts!
For Model AWS60DX (see Figure 12).
To replace a light tube, use a hex-head driver, remove the two
hex-head screws that hold a cover plate over the back section of
the light tube. Set the screws and cover plate aside for reassem
-
bly later.
Using a small flat-blade screwdriver, gently lever the front sec
-
tion of the light tube down to allow it to be pulled clear of the
light housing.
Disconnect the two insulated electrical connectors from the cabi
-
net’s electrical cable and discard the old light tube. Reconnect
the electrical connector of the new light tube to the cabinet’s
electrical cable connectors. Make sure it is secure and fully
installed.
Carefully realign the light tube’s electrical terminal back into
the rear of the light enclosure channel making sure not to crimp
them. Gently insert the light tube along the length of the light
enclosure channel. Press the light tube gently into the light
enclosure channel. Only a small part of the light tube should
project below the ceiling of the wine storage unit. DO NOT USE
A HAMMER TO FIT THE LIGHT TUBE.
Place the light tube terminal cover plate back in the original
position on the light enclosure’s flange. Reuse the original two
screws to secure it in place. Plug the wine storage unit into the
electrical socket. Check to see if the light tube operates prop
-
erly. Your light tube’s replacement is complete.
For model ADZ60 (see Figure 13).
This product uses two, 6 watt light tubes to illuminate the
interior of the dual zone wine storage unit: one in the upper
compartment and one in the lower compartment. The upper
compartment light tube is located behind the display housing.
The lower compartment light tube is located on the underside of
the divider that separates the compartments.
To replace the light tube, disconnect power to the unit. Use a
hex-head driver to remove the two hex-head screws holding the
old light tube in place. Disconnect the electrical plug from the
cabinet’s electrical receptacle and discard the old light tube. Re
-
connect the electrical plug of the new light tube to the cabinet’s
electrical receptacle. Make sure it is secure and fully installed.
Using the hex-head driver, re secure the two hex-head screws to
secure the light tube in place. Plug the unit into the electrical
socket. Check to see if the light tube operates properly. Your
light tube’s replacement is complete.
12
Figure 12
Channel in
liner
Light tube
Cover plate
Connector
Hex head
screw
Light
assembly
Ground
wire
Plug
Figure 13
