ELECTRICAL CONNECTION
Do not use an extension cord with this appliance.
Figure 5
Green/Yellow
(earth)
Fuse (13A)
Blue (neutral)
Brown (live)
If you replace the fuse, the cover must be refitted. If the cover
is lost, the plug must not be used until a replacement has been
obtained from your supplier. The color of the fuse cover is that
of the insert in the base of the fuse recess or elsewhere on the
plug. Always state this color when ordering a replacement cover.
If your appliance has a moulded plug, you do NOT have to do
the following assembly as shown in Figure 5. Appliances with
moulded plugs are ready to use as is.
IMPORTANT: The wires should be connected to the terminals of
the plug as follows:
• Earth to the terminal marked E or coloured Green or Green/
Yellow.
• Neutral to the terminal marked N or coloured Blue.
• Live to the terminal marked L or coloured Brown.
When wiring the plug, ensure that all strands of wire are re
-
tained in each terminal. The flexible main cable, plug and socket
must not be exposed to flue products or be allowed to come in
contact with a hot surface. The cable must not be trapped or
pulled taut when the appliance is pushed into position.
THIS UNIT SHOULD NOT, UNDER ANY CIRCUMSTANCES, BE UN
-
EARTHED.
Electrical Connection
Use nominal 230 VAC, 50 Hz only.
THIS APPLIANCE MUST BE EARTHED. All external wiring must
comply with the IEE Regulations for the Electrical Equipment of
Buildings. Connections to the electrical supply can be made with
either a plug and socket or be permanently wired via a double-
pole switch.
The appliance is supplied with a 250VAC PVC (85 degrees C) core
cable (0.5mm x 2 metres long). Any replacement cable fitted
must follow this specification. The unit may be supplied with
either a moulded or rewirable plug. Should the plug not fit the
socket at the installation site, it should be removed and replaced
with the correct type of plug.
If a moulded plug is fitted which is not suitable, it must be re
-
moved and disposed of. To avoid the risk of electrocution, a plug
must not be left where a child may plug it into a supply socket.
It must not be used for any other appliance. A three pin plug to
BS 1363 with a capacity of not less than 13A must be used and
fitted with a 13A fuse “ASTA” approved to BS 1363.
5
Figure 4
Toe kick (Front Grille)
Toe kick screw
