CONVERSION
Check the appliance is electrically safe and gas sound when you have finished.
23
Fig. 8.3
Fig. 8.4
Fig. 8.5
Valve Adjustment
Disconnect from the electricity supply.
Pull off all the control knobs, remove the bezels and control
panel.
Using a flat headed screwdriver replace the bypass screws
with the screws from the LPG conversion kit. Be sure to save
the screws removed from the appliance for possible future
use.
Refit the control panel and control knobs.
Ovens
Remove the 4 fixing screws on the toe kick panel. Hold the
bottom edge, lift up slightly and gently pull towards you.]
Remove the 2 screws holding the orifice bracket
.
Locate the orifice and remove using an adjustable wrench.
Replace with oven burner orifice 132 for the main oven and
orifice 110 for the small oven.
Reassemble in the reverse order.
Broiler
Remove the rear guard and cover.
Using a wrench hold the orifice housing whilst removing the
nut. Remove the orifice from its holder and replace with the
broiler orifice for LPG (118).
Gas Regulator
The gas regulator is located on the bottom left hand side, at
the rear of the appliance.
Unscrew the cap from the front of the regulator housing
(Fig. 8.4)
. Unscrew the plastic insert from the cap, turn it
round and screw back into the cap
(Fig. 8.5)
.
Reassemble in the reverse order.
Natural Gas
LPG
Summary of Contents for APRO36AGSS
Page 1: ...APRO36AGSS 36 All Gas User Guide Installation and Service Instructions U110591 01...
Page 4: ...iv...
Page 30: ...26 Notes...
Page 31: ...27 Notes...
