6
Using the sparkling water maker
Your new sparkling water maker enables you to carbonate your own water, which
you can then flavour with AGA concentrates. To carbonate your own water, you
need the AGA 425 g carbon dioxide gas cylinder. When the cylinder is empty, a
replacement can be bought from the store where you made your original purchase
and the old bottle returned for deposit.
Inserting the gas cylinder
Remove the seal and the protective cap from the cylinder. Keep the cap in a safe
place as it will be needed when you replace the cylinder when empty. Place the
carbonator on a flat surface and remove the back cover of the machine: hold in the
catches on the side and angle the cover backwards and then lift it upwards.
Tilt the sparkling water maker forwards and insert the gas cylinder through the
opening in the bottom of the machine so that the cylinder is standing on the work
surface. Gently tilt the sparkling water maker back so that the upper part of the
machine rests against the threaded neck of the cylinder.
Screw the cylinder into the machine as far as
it will go (see illustration), at which point the
sparkling water maker will have returned to
its original resting position. Make sure that
the cylinder is firmly in place.
Now replace the back cover by inserting the
bottom lip into the hole in the base and then
angling the cover forward carefully until you
hear a click from the catches.
O54504_A6_
AGA
_Balance_manual.indd 6
2017-11-09 14:29
