SECTION 2 - LIGHTING and OPERATIONS
Open Top
1. Press and turn knob to full flame position.
2. Light burner using taper or match and continue to
hold knob in for a further 20 seconds before
release.
3. Burner should remain lit; if burner goes out return
to Step 1 and repeat ignition procedure.
4. When burner remains lit, turn knob to required
position.
To Shut the Open Top OFF
Turn knob to OFF position.
Solid Top
The solid hotplate is composed of two filling plates, a
ring and centre bullseye. A double-ring burner is
located below hotplate.
1. Ensure mains gas is turned on.
2. Remove bullseye castings from solid top hob.
3. Turn control anti-clockwise to pilot ignition position
and push knob in.
4. Holding knob in fully, apply taper to pilot and
observe pilot lights.
5. When pilot is lit, continue to hold knob in fully for
20 seconds then release. If pilot is extinguished,
wait three minutes and repeat from Step 3.
6. Having established pilot condition, turn knob
anti-clockwise to FULL FLAME position. This will
light main burner.
7. For LOW FLAME operation, turn knob further
anti-clockwise to LOW FLAME position.
8. Replace bullseye castings.
To Shut the Solid Top OFF
1. Turn to pilot position, ready for next operation.
2. To extinguish completely, turn to OFF position.
Wok Burner
1. Ensure mains gas is turned on.
2. Turn control anti-clockwise to pilot ignition position
and push knob in.
3. Holding knob in fully, apply taper to pilot and
observe that pilot lights.
4. When pilot is lit, continue to hold knob in fully for
20 seconds before release. If pilot is extinguished,
wait 3 minutes and repeat from Step 2.
5. Having established pilot condition, turn knob
anti-clockwise to full flame position to light burner.
6. For low flame operation, turn knob further
anti-clockwise to low flame position.
To Shut the Wok Burner OFF
1. Turn to pilot position in readiness for next
operation.
2. To extinguish completely, turn to OFF position.
Oven
1. Open oven doors.
2. Turn thermostat knob to maximum setting and
push in. This will establish a flow of gas to oven
burner.
3. Continue to press knob in and at the same time,
push piezo ignitor button situated below oven
compartment to provide a spark at oven burner.
4. Having established burner flame, maintain
pressure on knob for a further 20 seconds before
release.
5. Burner should remain lit. Should burner fail to
remain lit, wait 3 minutes then return to Step 2 and
repeat ignition procedure.
6. When burner remains lit, turn thermostat to
required position.
To Shut the Oven OFF
To extinguish burner, turn thermostat control knob to
OFF position.
