background image

Product

Sealant

Finish

Cleaner

Maintenance

Terracotta 
(inc. Reclaimed terracotta)

Fired Earth Linseed Sealer*

Wax paste (high
protection/high
maintenance/
colour enhancer)

Cotto Rapid 
(low maintenance,
less protective)*

For waxed floors, use Fired Earth
Super Floor; for Cotto Rapid 
floors, use Clean Stone 1*

For waxed floors it is advisable to apply further 
wax coats from time to time; For Cotto Rapid floors, 
reapply when floor appears dull*

Pre-sealed terracotta

Not required

Cotto Rapid*

Clean Stone 1*

Reapply Cotto Rapid when floor appears dull*

Lubelska bricks

Fired Earth Stone Shield*

Cotto Rapid*

Clean Stone 1*

Reapply Cotto Rapid when floor appears dull*

Encaustic 
(follow specific instructions)

Fired Earth Stone Shield*

Fired Earth Stone Finish*

Fired Earth Super Floor*

Reapply Fired Earth Stone Finish when floor appears dull*

Geometrics

MN Stain Stop*

Not required

MN Easy Care*

Not required

Slate

Stone Shield 
in dry areas*

MN Stain Stop
in wet areas*

Fired Earth Stone Finish if using 
Fired Earth Stone Shield only*

If finishing with Fired Earth 
Stone Finish, use Fired Earth
Super Floor; if sealing with MN
Stain Stop* use MN Easy Care*

For wet areas re-apply MN Stain Stop* when tiles appears porous; For dry 
areas, re-apply Fired Earth Stone Finish when tiles appear dull. Wax paste 
will be required for Pale Classic and chipped edge tile (use only in dry areas)

Natural Stone 
(inc. Stone Mosaics)

MN Stain Stop to
retain natural
appearance*

Stone Shield to
enhance natural
colours*

If sealing(dry areas only) with 
Fired Earth Stone Shield, use Fired 
Earth Stone Finish; if sealing with 
MN Stain Stop no finish is required*

If finishing with Fired Earth 
Stone Finish, use Fired Earth
Super Floor; if sealing with MN
Stain Stop use MN Easy Care*

For MN Stain floors, it is advisable to re-apply the MN Stain Stop if 
tiles become porous. For Fired Earth Stone Finish floors, reapply when 
floor appears dull*

Roman Mosaics

MN Stain Stop*

Not required

MN Easy Care*

It is advisable to reapply the MN Stain Stop* 
if tiles becomes porous

Porcelain

Tiles do not require sealing; seal 
grout joints with MN Stain Stop*

Not required

MN Easy Care*

Not required

Glass

Tiles do not require sealing; seal 
grout joints with MN Stain Stop*

Not required

MN Easy Care*

Not required

Product Selector  2

- Sealing, Finishing and Maintenance 

Quick reference guide

23

22

Read the instructions on the packaging of Adhesives, Grouts and Sealants very carefully. 

Notes: 

Use this table in conjunction with Fired Earth Installation guides.

Summary of Contents for Fired Earth













Reviews: