AGA MASTERCHEF DELUXE 90 DUAL FUEL, User'S Manual & Installation Instructions

28

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

130 mm min

Positioning the Cooker

Fig. 10.1

 and 

Fig. 10.2 

show the minimum recommended 

distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
The hotplate surround should be level with, or above, 

any adjacent work surface. A gap of 75 mm should be left 

between each side of the cooker 

ABOVE

 the hotplate level 

and any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or 

ceramic tiles), this can be reduced to 25 mm.
A minimum space of 800 mm is required between the top of 

the hob and a horizontal combustible surface.

*Any cookerhood should be installed in accordance with the 

hood manufacturer’s instructions.
**Any splashback must be fitted in accordance with the 

manufacturers instructions. Allowance should be made for the 

additional height of the flue trim, which is fitted to the cooker 

hob. 

Surfaces of furniture and walls at the sides and rear of the 

appliance should be heat, splash and steam resistant. Certain 

types of vinyl or laminate kitchen furniture are particularly 

prone to heat damage and discolouration. We cannot accept 

responsibility for damage caused by normal use of the 

cooker to any material that de-laminates or discolours at 

temperatures less than 65 °C above room temperature.

DO NOT 

box the cooker in – it must be possible to move the 

cooker in and out for cleaning and servicing.
If the cooker is near a corner of the kitchen, a clearance of 

130 mm is required to allow the oven doors to open 

(Fig. 

10.3)

. The actual opening of the doors is slightly less, but 

this allows for some protection of your hand as you open the 

door.

Moving the Cooker

n

On no account try and move the cooker while it is 

plugged into the electricity supply.

n

The cooker is very heavy, so take great care.

We recommend that two people manoeuvre the cooker. 

Make sure that the floor covering is firmly fixed, or removed, 

to prevent it being disturbed when moving the cooker 

around.
To help you, there are two levelling rollers at the back, and 

two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt 

the cooker backwards and remove the front half of the 

polystyrene base 

(Fig. 10.4)

. 

Repeat from the back and remove the rear half of the 

polystyrene base.

5 mm

5 mm

Height to Hotplate

905 mm min

930 mm max

Height to Flue Trim

920 mm min

945 mm max

800 mm min

410 mm min

410 mm min

Wall

Wall

910 mm

75 mm min

75 mm min

check cookerhood instructions for actual dimensions

900 mm

Fig. 10.3 

Fig. 10.4 

ArtNo.245-0031 - 110 IN G5 - Masterchef -  Cooker clearance 2

75 mm

min

75 mm

min

800 mm

min

900 mm

min

925 mm

max

Fig. 10.1 

Fig. 10.2