29
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability
bracket
Floor
Stability
location
bracket
Wall
Typical wall mounting
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
Stability
location
bracket
Typical floor mounting
Alternative positions
for stability location
bracket
Stability chain
ArtNo.010-0004 Moving the cooker
Fig. 10.6
Fig. 10.7
Fig. 10.8
Fig. 10.5
Fig. 10.9
Fig. 10.10
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting nut
(Fig. 10.5)
. Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the cardboard base tray. Open the
oven doors so that you can get a good grip on the bottom of
the fascia panel as you move the oven
(Fig. 10.6)
.
Carefully push the cooker backwards off the base tray.
Remove the base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it.
n
DO NOT use the door handles or control knobs to
manoeuvre the cooker.
Fitting the Stability Bracket or Chain
Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in
Fig. 10.7
and
Fig. 10.8
.
If you are using a stability chain (
Fig. 10.7
) then the chain
should be kept as short as is practicable and fixed firmly to
the rear of the cooker.
If you are using a stability bracket; first attach the bracket
location device to the rear of the cooker (
Fig. 10.8
). Then
adjust the bracket to engage through the slot of the device
(
Fig. 10.9
and
Fig. 10.10
).
Repositioning the Cooker Following
Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig. 10.6)
, you need to check behind the cooker to make
sure that the gas hose is not caught.
As you progress, make sure that both the electricity cable and
gas hose always have sufficient slack to allow the cooker to
move.
With a stability chain fitted, release it as you ease the cooker out.
Do not forget to refit it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.
Summary of Contents for MASTERCHEF DELUXE 90 DUAL FUEL
