AGA PRO+ APRO36DFSS, User Manual & Installation & Service Instructions

CONVERSION

Check the appliance is electrically safe and gas sound when you have finished.

25

ArtNo.270-0029 - Prof+ 90SC annotated

Fig. 8.3 

Fig. 8.4 

Fig. 8.5 

Valve Adjustment

Disconnect from the electricity supply.

Pull off all the control knobs, remove the bezels and control 

panel. 
Using a flat headed screwdriver replace the bypass screws 

with the screws from the LPG conversion kit. Be sure to save 

the screws removed from the appliance for possible future 

use.
Refit the control panel and control knobs.

Gas Regulator

To access the gas regulator 

(Fig. 8.3)

 remove the fixing 

screws on the toe kick panel. Hold the bottom edge, lift up 

slightly and gently pull towards you.
Unscrew the cap from the front of the regulator housing  

(Fig. 8.4)

. Unscrew the plastic insert from the cap, turn it 

round and screw back into the cap 

(Fig. 8.5)

. 

Reassemble in the reverse order.

Pressure Testing

Connect the appliance to the gas supply. Check the appliance 

is gas sound.
The gas pressure can be measured at the pressure test point 

on the appliance at the right hand, rear, cooktop burner. 

Remove the burner cap, base and head.

n



Disconnect from the electricity supply

Manually ignite 2 other cooktop burners 

see ”Igniting Cooktop 

Burners without Electricity” on page 6

. Use a rubber hose 

with an inside diameter of ¼” and hold the end of the tube, 

tightly, over the orifice. 
For proper operation, the pressure of LP supplied to the 

regulator must be between 10’’ and 13’’ of water column  

(2.49 - 3.24 kPa).
When checking for proper operation of the regulator, the 

inlet pressure must be at least 1’’ (0.25 kPa) greater than the 

operating (manifold) pressure as given above.
The pressure regulator located at the inlet of the range 

manifold must remain in the supply line regardless of 

whether natural or LP gas is being used.

Attach the Serial Plate

Record the model and serial number on the conversion serial 

plate provided with this kit. The information can be obtained 

from the existing plate.
Attach the new plate as close as possible to the existing one. 

Natural Gas

LPG

Toe kick

Regulator

(behind toe kick)