20110810_iMeter_guidelines.doc
Page 10/16
10/08/2011
The ON/OFF button is used to switch on the Bluetooth state and to switch off back to the low
consumption mode.
The Bluetooth light (green) can show the following states:
•
OFF, when the dongle is low consumption mode
•
Flashing, when the dongle is ON but it still doesn’t receive any Bluetooth connection
•
Constant lighting, when the dongle is connected through Bluetooth to the PDA. In this state it
also show some intermittent lighting when there is data transfer
The battery and RF activity light (green/red), have several states:
•
When the dongle is in the low consume mode and it is not charging, approximately every 5
seconds the red light flashes 1 to 3 times. The number of flashes shows the battery level of
the dongle (1: very low, 2: low and 3: normal).
•
When the dongle is charging the light is in constant red.
•
When the charging is over and while the dongle is still connected to the power (USB
connection), the green light is permanently on.
•
The green light is flashing slightly in green when the dongle is on, and when there is Radio
Frequency activity.
For the installation, the dongle must be turned on, and placed on the iMeter.
3.2. IMeter PDA manager to set up
The configuration and installation is done by PDA software named WCEiMeterMgr, while placing the
dongle in the position showed above. The following part explains the main steps of how to use the
PDA manager to set up the iMeter. There is a user manual for the WCEiMeterMgr with further
information of the setting up of the Bluetooth connection with the dongle attached.
