20110810_iMeter_guidelines.doc
Page 3/16
10/08/2011
1.
Introduction
The present document is aimed at describing the main information for setting up the AGBAR
product named iMeter, and its basic operating instructions. The iMeter is a pulse collector and
logger, which is used for water metering sending the data by GPRS.
Figure 1. iMeter connected to a Sensus meter
The iMeter is a data logger which is connected to a water meter through a pulse captor. The iMeter
is wired to the pulse captor, and the pulse captor fixed on the meter. The iMeter collects pulses
according to the frequency displayed by its configuration, and delivers the data to the AGBAR
servers, where is collected and processed by AGBAR systems. This data is showed in the AGBAR
AMR (Automatic Meter Reading) webpage.
For the iMeter installation is needed a Palfi dongle and a PDA with the configuration manager
software.
