E - 2
Introduction
Get Started
Connect the plug at the end of the power supply into the socket labelled ”Power” until you
hear it click.
Connect one end of the ISDN connection cable into the socket labelled SO until you her it click
in place.
Connect the other end of the cable to the NTTP of the network provider or the installed socket.
Connect the TAE Adaptors to the telephone system.
Connect the plugs of your telephone equipment to the TAE adaptors.
The default setting of the AC16 WebPhonie is that the first connection is extension 11 and the
second connection is extension 12.
Plug the power supply into the 230V main socket. The green LED will light up.
Enter the MSN numbers (see below).
You now can make calls. After lifting the telephone receiver you will hear the dial tone of the
telephone exchange.
An incoming call received on one of your MSN numbers will ring extension 11 and 12.
Enter MSN numbers quickly
END
MSN numbers on which you can be called can be programmed quickly and easily. With this
function you can enter the MSN and at the same time allocate each MSN to the connected
telephone apparatus.
Example: For the first socket (Phone) you enter the telephone number (345678). For the se-
cond socket (Fax) you enter the phone number (345677). Therefore, callers ringing 345678 will
call your phone and callers ringing 345677 will call your fax machine.
For further information see ”Programming Instruction”.
lift receiver
MSN
quick programming
h
* 6767
6
z #
q
ª
replace
receiver
Confirmation
tone
Stop programming mode:
h
*END
q
ª
Enter Multi
Subscriber
Number (MSN)
M
SN-
Index
Start programming mode:
h
*PRO
q
ª
(if required enter PIN, not
activated in default)
PRO
Summary of Contents for AC 14
