U - 8
User Guide
Malicious Call Identification (MCID)
This feature will have to be supplied by your network provider.
The ISDN exchange will store the callers number and the date and time of the call.
This trace can be activated during the call or after the caller has hung up but must be
activated before you terminate the call.
t
r
*326
q
ª
Notes
You can continue the call after
rS326
Until you return to the caller he will hear Music on Hold if applicable.
You hear the error tone if:
-Malicious Call Identification has not been made available by your network operator
OR
-when the caller could not be identified by the telephone exchange.
Busy on Busy
This feature is used in the following situation. If an incoming line is programmed to ring
several phones, then each time a new call arrives the free extensions within the group will
ring. If, however, for some reason your are the only one in the office and are already on a call
then the next incoming call would cause the free extensions to ring. It may not be possible to
answer the new call in time and therefore the caller may get the impression that no one is in
the office. If Busy on Busy is set on the other hand than any extension within the ringing
group who is on a call will cause for a new caller to hear busy tone. Note: This will not place
restrictions on outgoing calls.
h
*287
q
ª
Lift receiver
Replace
receiver
Busy on Busy
An ISDN terminal that is connected in parallel to the telephone system on a point-to-
multipoint line and to which the same number as the system has been assigned will always
ring, regardless if BUSY ON BUSY is active or not.
2
3
off
On
6
2
Enter specific MSN
Busy on Busy on/off for
all MSNs
z
#
Notes
Conduct external
call
Replace receiver
Acknowledgement
tone
Identify caller
Enquiry
Summary of Contents for AC 14
