P - 2
Programming
Remote setting - Remote configuration
Your telephone system can be programmed remotely to your requirements. To allow
remote maintenance you must set the telephone number from which your maintainer
is calling. It is only possible to gain access to the system if the programmed number
corresponds to the transmitted CLIP of the maintainers number. You may restrict access to
the telephone book of the system. Your system can be programmed for up to 8 hours from
the time you released your system for remote maintenance, after which it will lock again. You
must end your own programming during the time in which the system is programmed
remotely.
enter Remote Configuration Number
h
*337
3z#
q
ª
Lift receiver
Remote
configuration
Enter Remote Configuration
number
Replace
receiver
h
*373
q
ª
Lift receiver
Allow
Replace
receiver
Confirmation
tone
3
5
Enter
Delete
Confirmation
tone
4
5
Without phone Book
With Phone Book
Allow Remote configuration
Summary of Contents for AC 14
