P - 3
Programming
Programming with a telephone
Programming with the
S
procedure always covers the steps:
Start programming mode, input and exit programming mode.
When programming, pay attention to the dial tones or dial pulses in the handset. Wait after
enter- ing every digit until the digit has been dialed. Only then will you hear the acknowledge
tone if your entry is valid or the error tone if your entry is invalid.
Recommendation: Use a DTMF telephone (touch-tone dialing) for faster programming.
You can press the loudspeaker button instead of „Lift handset“ or „Replace handset“ when
programming on the system telephone.
Start Programming Mode
To be able to change settings you must first start the programming mode. While your system
is in programming mode, you are not able to make a call!
Lift
reciever
Start Programming Mode
Enter setup code?
If you hear the acknowledge tone after
*PRO
, no setup code is programmed in the
telephone system. It is not necessary to enter the setup code. If you hear the error tone, the
last input is wrong. Start the input again from the beginning. If you do not hear any tone
after
*PRO
, a setup code is programmed in the telephone system. Enter the setup code
in 4 digits. If the code is correct, you will hear the acknowledge tone. If the code is wrong, you
will hear the error tone. Replace the handset and start the whole input again from the
beginning with the correct setup code.
h
*PRO
q
ª
Replace receiver
Confirmation tone,
otherwise enter System
PIN
(Setup-Code)
Summary of Contents for AC 14
