E - 5
Introduction
Only analogue Apparatus which are approved to be connected to the Public Switched Telepho-
ne Network (PSTN) may be connected to the analogue side of the system.
This includes all 2 wire telephones, answering -, fax machines, and modems.
The system supports both dialling method Loop Disconnect (LD) or Dual Tone Multi Frequency
(DTMF). DTMF is a faster dialling method. The system will dedect the dialling method
automatically.
From an analogue phone, you can call any extension free of charge by dialling the
internal phone number. You can call an external number after seizing an outside line.(B
channel) Do do this dial 9 (0) to get an outside line and then dial the telephone number
required.
If you set “spontaneous exchange line seizure with internal ” for your telephone extension
then you must press the hash button before the internal phone number. Note in this mode
you cannot call an extension if your phone is an older LD or rotary type dial phone.
To carry out system functions, your phone must have a STAR Button (*). The sequence to
enter will be * followed by the function number. If your phone is an older type LD phone then
you can dial 99 instead of * .
To make an enquiry call you phone must have an R Button (Recall Button). The signalling for
this must be set to Timed Break Recall (TBR). On older rotary dial phones you do not need to
press the R Button when making an enquiry call. System functions such as last number
redial, abbreviated dialling etc, can be carried out from any LD phone. Details of such
operations are given in this manual and in the short reference guide under
Analogue and ISDN Terminals.
You can also use the functions of a standard analogue telephone (e.g. redial, abbreviated
dialling) in conjunction with your telephone system. Please refer to the operating instructions
for the telephone concerned for details of these functions.
Details of how to operate the functions of your telephone system that you are able to use from
a standard analog telephone set to DTMF are given in this instruction manual and in the
„short-form operating instructions for analogue and ISDN terminals“.
Each programming entry will be acknowledged by a confirmation tone. If this tone is not
received or if an error tone is returned then you must repeat this entry.
The telephone system is forwarding counting pulses to analogue terminals to display
connection charges (charge pulses).
For data transfer via the analogue ports, the telephone system supports the V.90 standard (up
to 56600 bps, a reduction in speed is possible due to transmission path and cables used, down
to 33600 bps V.34+).When operating a modem, it is imperative to configure the modem to blind
dialling because most modems do not detect the dial tone of a telephone system.On modems
that operate with the Hayes command set, blind dialling is set by means of the X0..X4
parameters.
Important notes on using analogue
equipment
Summary of Contents for AC 14
