P - 16
Programming
Protecting your system against
unauthorised access (PIN numbers)
The Use of PIN numbers will secure the system from unauthorized access. PIN numbers
can be set for the following sections:
System PIN
- or main programming PIN. In default every user may program the system.
You can deny this access by setting a four digit PIN number which has to be entered
before the system can be programmed. In default this PIN has been preset to 2580 which is
the middle row of the telephone keypad from top to bottom, however this PIN is disabled in
the default setting.
Charge PIN
- in the default setting every user can display and delete the call meters. This
use can be restricted and call meters can only be cleared by entering a four digit code.
In default the system is shipped with no PIN number set.
Service PIN
- or Remote Maintenance. This PIN will give access for the system to be
programmed remotely. If this PIN is set then the maintainer can gain access to your system
regardless of the origination of the call and you do not have to enter his telephone number.
The condition is that you must have released the system for remote maintenance.
h
*265
q
ª
Lift receiver
Set System PIN
System PIN
Enter new PIN (4
digits)
replace
receiver
Confirmation
tone
2
3
7
6
Pz
Start Programming mode with:
h
*PRO
q
ª
Continue programming or end programming:
h
*END
q
ª
off
On
Standard PIN (2580)
Enter new PIN
Summary of Contents for AC 14
