2 - 15
Analogue and
ISDN-Phones
Night Service on / off from an
external source
If the selection ‘all off/all on’ is set up when Night Service is switched on/off, door call vari-
ant 2 is switched on/off at the same time.
Notes
Switching Call Forwarding (Exten-
sion Call Forwarding) on/ off
With this setting incoming calls can be forwarded to alternative extensions if:
-after a preset number of rings the call remains unanswered.
-Immediately if the telephone is busy and call waiting indication is not possible.
This feature can be set at any time from any extension or remotely for any exchange line
connected to your system.
The Call Forwarding is set for each extension in the programming table of the Call Forward
section.
h
P Z
Q
Q
P Z
Lift receiver
Ringing tone
2 to 3 rings
Enter the direct dialling
in or multiple subscriber
number of the switching
box
Wait for 5 seconds
internal music on
hold
Enter the code number
of the switching box
within 15 seconds as a
DTMF signal
Q
P S 53 P Z
P Z
P R
Q
P ª
Replace
receiver
Acknowledgement
tone
Wate for 5 seconds
internal music on
hold if the code
number is correct
on / off:
Switch call variant 2
1 = on
0 = off
2 = all off
3 = all on
Enter phone number to
switch individually
Conclude
input
(
)
Summary of Contents for AS 100 IT
