System Telephone ST 42
16
Place of Installation
Install ST 42 in an appropriate place. Please pay attention to the following during the installation:
- Not in places,where the phone can be sprayed with water or chemicals.
- Synthetic support at the base of the phone:
Your apparatus was manufactured for normal conditions of use.Chemicals used in the production
or care of furniture can cause changes to the synthetic support of the phone. Such apparatussup-
ports changed by extraneous influence can leave behind unpleasant marks. Due to understandab-
le reasons,liability for such damages can not be taken. Use therefore a non-slippery base for your
phone,especially on new or freshly vanished furniture.
Cleaning
You can easily clean your phone. Pay attention to the following:
- Wipe the phone with slightly moist or antistatic cloth.
- Never use dry cloth (charging could lead to defective electronics).
- Take care by all means that moisture does not ooze into the phone (switch and contacts could be
damaged).
Inserting inscription for the function
keys
Your ST 42 includes a printed designation strip which shows the but-
ton allocation in default. You may use the reverse to enter your own
designation.
Use a finger-nail between the upper end of the window and the
phone casing. Pull the window downwards until it buckles. You can
now take it out.
Insert the inscription strips. You can print corresponding lebels on your PC, using the TK-Set
configuration programm.
Re-insert the window at the lower end in the recess for inlay. By pressing downwards,the window
buckles and you can replace it.
