198935 R17
27
5.3.5 Welded Hopper Make-Up Package - 19' x 35°
(P/N 234483)
Figure 8.
Welded Hopper Ladder Assembly - 19’
HOLES IN LADDER SUPPORT
CHANNELS ALIGN WITH MATING
HOLES ON THE LADDER SEGMENTS.
THIS IS THE BEST MEANS TO ALIGN
SUPPORT CHANNELS
ANGLE BRACKET
P/N 234522
DETAIL 1
BOTTOM TWO CAGE SECTION USES
25” & 30” VERTICAL SUPPORTS
18.2”
90.8"
25.0”
30.0”
BOTTOM CAGE
HOOPS BOLT TO
SUPPORT CHANNELS
LADDER
INSTALL SUPPORT CHANNELS (P/N 234491)
SO THAT FLANGES POINT OUTWARDS
USE 3/8” x 1” BOLTS TO
SECURE LADDER TO THE
SUPPORT CHANNELS
SECTION A–A
STANDARD CAGE
HOOP (P/N 234161)
BLOT TO SC
LADDER CLIP
LADDER
LADDER SUPPORT CHANNEL
WALL SHEET
HOPPER RING BEAM
3/8” x 1¼” BOLT
A
A
NOTE:
-
HOLES ON THE TOP OF SUPPORT CHANNELS ALIGN & BOLT WITH
MATING HOLES ON THE LADDER SEGMENT & HOPPER RING BEAM
-
SC LADDER CLIPS ARE REQUIRED AT THIS LOCATION
DETAIL 1
14.0”
SC CLIP
POSITION THE CENTRE OF
SC LADDER CLIP 14” UP
FROM HORIZONTAL SEAM
AND DRILL TWO HOLES
ON WALL SHEET CREST
HOPPER LADDER MAKE-UP PACKAGES – WIDE-CORR® GRAIN BIN