24
198935 R17
5.3.2 Welded Hopper Make-Up Package - 15' x 35°
(P/N 234531)
Figure 5.
Welded Hopper Ladder Assembly — 15’
USE 3/8” x 1” BOLTS TO
SECURE LADDER &
CAGE HOOP TO THE
SUPPORT CHANNEL
LADDER
CAGE HOOP
INSTALL LADDER SUPPORT
CHANNELS (P/N 234488) SO THAT
FLANGES POINT OUTWARDS
3/
8”
x
1
¼
” B
O
LT
S
SECTION A–A
(FOR BOTH BOTTOM CAGE HOOPS)
LADDER SUPPORT
CHANNEL
BOTTOM CAGE HOOP
(P/N 234162)
LADDER
WALL SHEET
HOPPER RING BEAM
3/8” x 1¼” BOLT
A
A
NOTE:
-
HOLES ON THE TOP OF SUPPORT CHANNELS ALIGN & BOLT
WITH MATING HOLES ON THE LADDER SEGMENT & HOPPER
RING BEAM
-
NO LADDER CLIPS ARE REQUIRED AT THIS LOCATION
DETAIL 1
ANGLE BRACKET
P/N 234522
TRIM BOTTOM LADDER
SEGMENT TO FIT IF NECESSARY
84.3”
44.0”
BOTTOM CAGE
HOOPS BOLT TO
SUPPORT CHANNELS
BOTTOM CAGE SECTIONS USE 44”
VERTICAL SUPPORT (AS SHOWN)
DETAIL 1
HOLES IN LADDER SUPPORT
CHANNELS ALIGN WITH MATING
HOLES ON THE LADDER SEGMENTS.
THIS IS THE BEST MEANS TO ALIGN
SUPPORT CHANNELS
HOPPER LADDER MAKE-UP PACKAGES – WIDE-CORR® GRAIN BIN