•
To configure a four-card module, you can have one expansion card
above the master card and two below, or two expansion cards above
and one below (see illustration on page 13-4). Note the cables which
are used for each configuration, and the side of the master card
which is used for connecting. If the master card is below the
expansion card, the connector on the left side of the master card
(when looking at back of mainframe) must be used; when the master
card is above the expansion card, the connector on the right side of
the master card must be used. See "To Install the Module" for the
installation procedure.
•
To configure a five-card module, the master card must go in the
middle slot, and two expansions cards are above it and two are below
it (see illustration on page 13-4). The two long cables (three
connectors) must be used. For the expansion cards above the master
card, use the connector on the left side of the master card (when
looking at back of mainframe); for the expansion cards below the
master card, the connector on the right side of the master card must
be used. See "To Install the Module" for the installation procedure.
Installation and Service
To Configure a Multi-card Module
13–6
Summary of Contents for 16517A
