Using Macros to Create a Trigger Specification
To configure a trigger specification using trigger macros, follow the
procedure below.
1
From the Trigger menu, enter the desired sequence level through the
Modify Trigger field, or by selecting a sequence level number.
See Also
"Editing Sequence Levels" and "Modify Trigger Field" found earlier in this
chapter for information on accessing levels.
2
From within the sequence level, select the Select New Macro field.
Select New Macro Field
3
Scroll and highlight the macro you want, then select the Select field.
4
Select the appropriate assignment fields and insert the desired
predefined resource terms, numeric values, and other parameter
fields required by the macro. Select the Done field.
See Also
"Resource Terms" found later in this chapter for information on using
predefined resource terms.
Select new macro field
Assignment field
The Trigger Menu
Using Macros to Create a Trigger Specification
4–11
Summary of Contents for 16517A
