Accumulate Field
The Accumulate field controls whether old data is cleared or displayed with
new data. The Accumulate field will toggle On/Off. When Accumulate is on,
the analyzer displays the data from a current acquisition on top of the
previously acquired data.
The time at which the old data is cleared depends on whether the analyzer is
run in Single or Repetitive mode. In Single mode, new data will be displayed
on top of the old each time the Run field is selected. In Repetitive mode,
data is cleared from the screen only when you start a run after stopping an
acquisition with the Stop field.
If you leave the Waveform menu, or pop up a menu over the waveform
display, any accumulated display data is lost and the accumulation process
starts over.
Accumulate Field
Accumulate field
The Waveform Menu
Accumulate Field
6–4
Summary of Contents for 16517A
