To copy ASCII measurement data
1
Set up the measurement you want to make, and run the analyzer to
acquire data.
For more information on setting up measurements, see the logic analyzer’s
User’s Guide.
2
Access the logic analyzer’s file system.
Refer to the chapter "Accessing the Logic Analyzer File System".
You can do this from the X Window interface, your computer using NFS or
ftp, from the front panel, or by programming the logic analyzer.
3
Copy the measurement data from the
\slot_a\data.asc
subdirectory.
In the analyzer’s file system, ASCII data files are located in
\slot_a\data.asc\{analyzer name}\{label name}.txt
.
There is an ASCII data file corresponding to each label name you have
created in the measurement module. The data files for each label are
overwritten by the analyzer each time new data is acquired.
1660CS-Series Only
Oscilloscope data is under
\slot_b\data.asc
. There is no subdirectory
matching
{analyzer name}
but there are files for both oscilloscope
channels.
See the example on the next page.
Retrieving and Restoring Data
To copy ASCII measurement data
4-3
Summary of Contents for 1660 CS Series
