Acquire the data 3–80
To test the trigger sensitivity (oscilloscope) 3–81
Set up the equipment 3–81
Set up the logic analyzer 3–82
Connect the logic analyzer 3–84
Acquire the data 3–84
Performance Test Record (logic analyzer) 3–85
Performance Test Record (oscilloscope) 3–88
Performance Test Record (pattern generator) 3–91
4 Calibrating and Adjusting
Logic analyzer calibration 4–2
To calibrate the oscilloscope 4–3
Set up the equipment 4–3
Load the Default Calibration Factors 4–4
Self Cal menu calibrations 4–5
To test the CAL OUTPUT ports 4–6
Set up the equipment 4–6
Set up the logic analyzer 4–7
Verify the DC CAL OUTPUT port 4–8
Set up the logic analyzer 4–9
Verify the AC CAL OUTPUT port 4–9
5 Troubleshooting
To use the flowcharts 5–2
To check the power-up tests 5–11
To run the self-tests 5–12
To test the power supply voltages 5–20
To test the LCD display signals 5–21
To test the keyboard signals 5–22
To test the flexible disk drive voltages 5–24
To test the hard disk drive voltages 5–26
To perform the BNC test 5–28
To test the logic analyzer probe cables 5–29
To verify pattern output (pattern generator option only) 5–33
The Ether address 5–35
To test the auxiliary power 5–36
6 Replacing Assemblies
To remove and replace the handle 6–5
To remove and replace the feet and tilt stand 6–5
To remove and replace the cover 6–5
Contents
vii
Summary of Contents for 1670G Series
