58
Chapter 2: Task Guide
Formatting Labels for Logic Analyzer Probes
3. In the Change Bit Order dialog:
•
To reorder the bits individually, enter the bit that the probe channel
should be mapped to.
•
To swap the high and low order bytes or words, select the button
Big
Endian to Little Endian
at the bottom of the dialog.
•
To return to sequentially ordered bits, select the button
Default Order
at the bottom of the dialog.
4. Select the
OK
button.
The label now shows an "R" to indicate that the assigned bit has been
reordered.
NOTE:
Labels with reordered bits cannot be used as
range terms
or <, <=,>, >= in
triggers.
To turn labels off or on
When you temporarily want to remove a label and its data, you can turn
off the label. The label name and its bit assignments are preserved.
To turn a label off
1. In the Format tab, select the label button that you want to turn off.
2. Choose
Label [ON]
to toggle it off.
At least one label must remain on.
To turn a label on
1. In the Format tab, select the label button that you want to turn on.
2. Choose
Label [OFF]
to toggle it on.
To display a label that was off
1. Turn on the label.
2. At the bottom of the window, select the
Apply
button.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
