Agilent 4155B/4156B VXIplug&play Driver User’s Guide, Edition 4
4-9
Sample Application Programs for HP VEE
Installation
Installation
This section explains the equipment and accessories required to use the sample
programs, and how to install the programs.
Required Equipment and Accessories
1. PC (AT-compatible) for Windows
HP VEE (version 4.0 or later) and the VXI
plug&play
drivers for the
4155B/4156B and E5250A must be installed in your PC and ready for use. See
Chapter 1.
A 3.5 inch flexible disk drive must be connected to your PC to install the sample
programs.
If you use the Cascade Microtech Summit series semi-auto prober, the prober
control software (PCS) supplied by Cascade Microtech, Inc. must be installed in
your PC and the prober must be connected to your PC via Cascade’s interface.
For the interface, and the operating system supported by the PCS, contact
Cascade Microtech, Inc. (PCS version 2.50 supports Windows 95 only).
2. HP VEE Sample Program Disk
3. Agilent 4155B or 4156B Semiconductor Parameter Analyzer
4. Agilent E5250A Low Leakage Switch Mainframe
Two E5252A matrix cards are required and must be installed in slot 1 and 2 of
the E5250A.
5. Cascade Microtech Summit Series Semi-Auto Prober
If you do not use the semi-auto prober, prepare the manual prober or test fixture,
such as Agilent 16442A, to connect the test devices.
6. Connection Cables
Four triaxial cables are required to connect the 4155B/4156B and E5250A.
Eight triaxial cables are required to connect the E5250A and the prober or test
fixture. You will also need coaxial cables, probe card, manipulators, or wire to
connect the test devices.
Two GPIB cables are required to connect the instruments and the PC.
