10-56
Programmer’s Guide
Menu Map with SCPI Commands
Menu Map for 8712ET/ES and 8714ET/ES
Table 10-24
SAVE RECALL
Functions, 8712ET/ES and 8714ET/ES (2 of 5)
1. This action valid with key record off.
KEYSTROKES
SCPI COMMAND
SAVE RECALL, Programs,
(continued)
Recall Program
(no SCPI command)
Run
PROG:STAT:RUN
Continue
PROG:STAT:CONT
Step
(no SCPI command)
Edit
(no SCPI command)
Key record on OFF
(no SCPI command)
Utilities
(menu selection only)
Clear Program
(no SCPI command)
Stack Size
(no SCPI command)
Secure
(no SCPI command)
IBASIC DISPLAY
(menu selection only)
None
DISP:PROG OFF
Full
DISP:PROG FULL
Upper
DISP:PROG UPP
Lower
DISP:PROG LOW
Save AUTOST
(no SCPI command)
IBASIC
(menu selection only)
Run
1
(no SCPI command)
Continue
(no SCPI command)
Step
(no SCPI command)
Edit
(no SCPI command)
Summary of Contents for 8712ES
