5CHGV[5[ODQNU
)GPGTCPHQTOCVKQP
The following general safety precautions must be observed during all
phases of operation, service, and repair of this instrument. Failure to
comply with these precautions or with specific warnings elsewhere in
this manual violates safety standards of design, manufacture, and
intended use of the instrument. Agilent Technologies assumes no liability
for the customer’s failure to comply with these requirements.
W A R N I N G
This is a Safety Class I instrument (provided with a protective
earthing ground, incorporated in the power cord). The mains plug
shall only be inserted in a socket outlet provided with a protective
earth contact. Any interruption of the protective conductor inside
or outside of the instrument is likely to make the instrument
dangerous. Intentional interruption is prohibited.
DO NOT operate the product in an explosive atmosphere or in the
presence of flammable gasses or fumes.
DO NOT use repaired fuses or short-circuited fuseholders: For continued
protection against fire, replace the line fuse(s) only with fuse(s) of the
same voltage and current rating and type.
DO NOT perform procedures involving cover or shield removal unless
you are qualified to do so: Operating personnel must not remove
equipment covers or shields. Procedures involving the removal of covers
and shields are for use by service-trained personnel only.
DO NOT service or adjust alone: Under certain conditions, dangerous
voltages may exist even with the equipment switched off. To avoid
dangerous electrical shock, service personnel must not attempt internal
service or adjustment unless another person, capable of rendering first
aid and resuscitation, is present.
DO NOT operate damaged equipment: Whenever it is possible that the
safety protection features built into this product have been impaired,
either through physical damage, excessive moisture, or any other reason,
REMOVE POWER and do not use the product until safe operation can be
E4416-90002.book Page 4 Wednesday, October 25, 2000 6:22 PM
Summary of Contents for E4416A
Page 8: ...5CHGV 5 ODQNU E4416 90002 book Page 6 Wednesday October 25 2000 6 22 PM ...
Page 10: ... QPVGPVU E4416 90002 book Page 8 Wednesday October 25 2000 6 22 PM ...
Page 11: ... GVVKPI 5VCTVGF E4416 90002 book Page 9 Wednesday October 25 2000 6 22 PM ...
Page 37: ...4GIWNCVQT PHQTOCVKQP E4416 90002 book Page 35 Wednesday October 25 2000 6 22 PM ...
