176
Chapter 7
Saving and Recalling Internal Data
Saving Measurement Data to Read in Spreadsheet Software (Saving in ASCII
Format)
displayed.
NOTE
Data that has been saved in ASCII format cannot be recalled and used by the E4991A. To
recall data to the E4991A, save it in binary format. For details, see the section “Saving and
Recalling Measurement Data in Binary Format” on page 172.
To save measurement data in ASCII format:
Step 1.
Perform the measurement for which you want to save data.
Step 2.
Right-click to open the shortcut menu and select
Save/Recall
. Alternatively, you can just
press
.
Step 3.
Click the
Save Data
button to open the
Save Data
dialog box (see Figure 7-4).
Step 4.
Select the
ASCII
option button in the
ASCII/Binary
section.
Step 5.
Click the check box(es) next to the type(s) of array(s) in the
Contents
section to choose the
data you want to save.
Step 6.
If you want to save the data to a floppy disk, insert the disk into the floppy disk drive.
NOTE
If you use the E4991A built-in floppy disk drive, use a 1.44 MB floppy disk in the DOS
format.
Step 7.
The current directory, including the drive name, is displayed in the top box. As shown in
Table 7-3 on page 169, navigate to the drive and directory where you want to save the file.
Step 8.
In the
File name
box, type the name of the file you want to save. If you want to use the
Table 7-4
Measurement Conditions for Saving Data
Measurement Condition
Value
Number of points
5
(for simplicity, the small number of points is used.)
Number of traces and trace types
2
×
scalar traces and 1
×
complex trace (
2 Sclr,1 Complex
)
Measurement parameters
Trace 1:
|Z|
, Trace 2:
θ
z
, Trace 4:
Z
Axis Format
Trace 1:
Linear Y-Axis
(
Lin Y-Axis
)
Trace 2:
Linear Y-Axis
(
Lin Y-Axis
)
Define Trace
Trace 1:
Data & Memory
, Trace 2:
Data & Memory
, Trace 4:
Data &
Memory
Check Box in
Contents
Section
Type of Internal Array
Data
Data arrays (see C in Figure 7-1)
Memory
Memory arrays (see D in Figure 7-1)
Trace Data
Data trace arrays (see E in Figure 7-1)
Trace Memory
Memory trace arrays (see F in Figure 7-1)
Summary of Contents for E4991A
