172
Chapter 7
Saving and Recalling Internal Data
Saving and Recalling Measurement Data in Binary Format
Saving and Recalling Measurement Data in Binary Format
If you want to save measurement data for later recall and use by the E4991A, you must
save it in binary format.
To save measurement data in binary format:
Step 1.
Perform the measurement for which you want to save data.
Step 2.
Right-click to open the shortcut menu and select
Save/Recall
. Alternatively, you can just
press
.
Step 3.
Click the
Save Data
button to open the
Save Data
dialog box (see Figure 7-4).
Figure 7-4
Save Data Dialog Box
Step 4.
Select the
Binary
option button in the
ASCII/Binary
section.
Step 5.
Click the check box(es) next to the type(s) of array(s) in the
Contents
section to choose the
data you want to save.
Step 6.
If you want to save the data to a floppy disk, insert the disk into the floppy disk drive.
NOTE
If you use the E4991A built-in floppy disk drive, use a 1.44 MB floppy disk in the DOS
format.
Step 7.
The current directory, including the drive name, is displayed in the top box. As shown in
Table 7-3 on page 169, navigate to the drive and directory where you want to save the file.
Check Box in
Contents
section
Type of Internal Array
Data
Data arrays (see C in Figure 7-1)
Memory
Memory arrays (see D in Figure 7-1)
Trace Data
Data trace arrays (see E in Figure 7-1)
Trace Memory
Memory trace arrays (see F in Figure 7-1)
Summary of Contents for E4991A
