Chapter 3
47
Quick Start Guide
Basic Measurement Procedures
3.
Qu
ick S
tar
t G
u
id
e
Basic Measurement Procedures
To better understanding how to use the E5070/E5071A, this section describes the basic
measurement procedure using the E5070/E5071A and presents an example of the
transmission measurement of a bandpass filter.
Basic Measurement Flow
STEP 1. Determining measurement conditions
o
Presetting the E5070/E5071A
o
Selecting the S-parameter
o
Selecting the data format
o
Specifying the frequency range
o
Specifying the number of measurement points
o
Specifying the power level
o
Specifying the IF bandwidth
STEP 2. Calibration
o
Specifying the calibration kit
o
Selecting the calibration type
o
Measuring the calibration data
o
Making the error correction ON
o
Saving the calibration data
STEP 3. Connecting the device under test (DUT)
o
Connecting the device under test (DUT)
o
Adjusting the scale
STEP 4. Analyzing measurement results
o
Analysis using the markers
STEP 5. Outputting measurement results
o
Storing the measurement file to a disk
Summary of Contents for E5070A ENA Series
