Chapter 5
179
Replacement Procedure
Replacement Procedure for E5092A-020
5. Rep
lacem
ent
Proce
dur
e
Front Chassis Detachment
Tools required
•
TORX screwdriver, T10, T15 and T20
Procedure
Refer to Figure 5-2 for this procedure.
Step 1.
Remove the outer cover as described in “Outer Cover Removal” on page 178.
Step 2.
Disconnect the connectors (item 1, 2, 3 and 6) from the A1 Switch control board.
Step 3.
Disconnect the flat cable connectors (item 4 and 5 ) from the A1 board.
Step 4.
Remove the six TORX T15 screws (item 7 ) fastening the side panel.
Step 5.
Remove the five TORX T10 screws (item 8 ) fastening the bottom chassis.
Step 6.
Slide the front chassis forward to detach from the back chassis.
Figure 5-2
Front chassis Detachment
Summary of Contents for E5092A
