202
Appendix A
Power Requirement
Turning the Power ON and OFF
Turning the Power ON and OFF
This section describes how to turn ON/OFF the E5092A and how to cut the supply of
power in an emergency.
Turning ON/OFF the power
Turning ON power
Step 1.
Check that the line switch in the lower left part of the front panel is pulled up (
). If it
is pushed in (
) which means the power is OFF, push the standby switch to pull it up
(
).
Step 2.
Push the line switch to push it in (
).
Turning OFF power
To turn OFF the E5092A, do the following.
•
Push the line switch in the lower left part of the front panel so that the switch pushed in
(
) is pulled up (
).
NOTE
To turn OFF the E5092A in normal times, press the line switch.
In normal times, never
disconnect the power cable to cut the supply of power to the power cable receptacle
on the rear panel.
Cutting supply of power
For the E5092A, the disconnecting device (the device to cut the supply of power) is the
plug of the power cable (on the power outlet side or the E5092A side).
If you need to cut the supply of power to avoid danger of electric shocks, disconnect the
plug of the power cable (on the power outlet side or the E5092A side).
NOTE
To turn OFF the power in normal times, be sure to follow the procedure in “Turning OFF
power”.
Summary of Contents for E5092A
