Installation Note E8364-90024
3
Contacting Agilent
www.agilent.com/find/assist
If you do not have access to the Internet, please contact your Agilent field engineer.
NOTE
In any correspondence or telephone conversation, refer to the Agilent product by
its model number and full serial number. With this information, the Agilent
representative can determine whether your product is still within its warranty
period.
About Installing the Upgrade Kit
IMPORTANT
Option 081 can only be installed on analyzers with the option
combinations listed below as “Products affected”. If your analyzer does not
have the proper options (as listed below), it will be necessary to install
those options BEFORE installing this option (Option 081).
Description of the Option 081 Reference Mixer Transfer
Switch Upgrade
This upgrade adds two high-speed microwave switches in the reference (R1) channel of the
PNA. These switches are used to switch a reference mixer in and out of the reference channel
signal path during calibration and measurement. This allows the user to easily switch
between standard S-parameter (non-frequency-offset) measurements and frequency offset
measurements that require an external reference mixer.
Products affected . . . . . . . . . . . . . . . . . . . . . . . . . . E8363B/C and E8364B/C; all option
combinations that include Option 014
Installation to be performed by . . . . . . . . . . . . . . Agilent service center or personnel
qualified by Agilent
Estimated installation time . . . . . . . . . . . . . . . . . 1.5 hours
Estimated adjustment time . . . . . . . . . . . . . . . . . 0.5 hours
Estimated full instrument calibration time . . . . 4.5 hours
