2
Do You Have Everything?
FieldFox
–To check for installed options, press
System
then
System Configuration
then
Options
then
Show Options
Phase stable jumper cable or adapters
– Used
to connect the FieldFox to devices with various
connector types and gender.
Attenuators
– Reduces power and prevents
damage to the FieldFox at the test ports.
Cal Kit
– T-Calibration Kits or other devices.
MicroSD card or USB flash drive
– Save files to
these devices for quick download to a PC.
USB Power Sensor
– For making Power Meter
measurements. (Opt 302)
Battery charger
or extra battery
The Power Button and LED
To turn power
ON
, briefly press the power button.
The LED is green. The boot-up takes about 60
seconds.
To switch to
Stand by
power (low battery drain)
briefly press the power button. The LED is amber
and blinks slowly. To turn power ON, briefly press
the power button. Power and settings are restored
instantly.
To turn Power
OFF
(very low battery drain) press
and hold the power button until power is shut OFF
- about 4 seconds. The LED is OFF.
