278
1100 Series WS MWS Reference Manual
A
Safety Information
General Safety Information
The following general safety precautions must be observed during all phases of
operation, service, and repair of this instrument. Failure to comply with these
precautions or with specific warnings elsewhere in this manual violates safety
standards of design, manufacture, and intended use of the instrument. Agilent
Technologies assumes no liability for the customer’s failure to comply with
these requirements.
General
This is a Safety Class I instrument (provided with terminal for protective
earthing) and has been manufactured and tested according to international
safety standards.
WA R N I N G
If you are using flammable solvents, remove the well-plates from the tray when you
turn off the sampler. You avoid the risk of building explosive gas mixtures in the tray
compartment.
WA R N I N G
If you are using flammable solvents, cover the well-plates with closing mats to
avoid the risk of building explosive gas mixtures.
WA R N I N G
After a leak in the sampler, make sure the leak plane is cleaned and dry.
WA R N I N G
Any adjustment, maintenance, and repair of the opened instrument under voltage is
forbidden.
WA R N I N G
Disconnect the instrument from the line and unplug the power cord before
maintenance.
Summary of Contents for G1367A
